新闻 for pc 新闻 for mobile
SHARE
Gantry five-axis proceesing machine-stop and maintenanceGOING | Oct 06th, 2024

1、Use the specified type of grease or guide oil, grease or lubricated each shaft, move each shaft in full stroke, so that the surface of the lead screw and guide rail is fully covered with grease or guide oil, and then stop the X, Y and Z axes near the center of the stroke.

2、Do not leave the handle in the spindle
Because there is residual cutting fluid on the cone of the spindle and the tool handle. Therefore, the tool handle cone and the spindle cone have the possibility of sticking. After the handle is removed, clean the spindle cone. Apply anti-rust oil to the tool handle and spindle cone.

3、Table surface, fixture surface will rust, to apply anti-rust oil, grease.

4、Verify that the battery alarm icon in the lower right corner of the display screen is displayed
If there is a battery alarm icon, but the battery is not replaced in time, when it is started again after a long time of power failure, the data such as processing procedures and machine parameters may be lost. Replace the battery regularly. Implement 1 week before long-term shutdown to confirm whether the battery is inserted incorrectly and whether the contact is poor.

  • CONTACT US
  • No.99 south Xuecan Road,Dongchen Town,Rugao city,Jiangsu Province
  • 400-820-0823
  • +86-0513-69963888
  • +86-13862177902
  • cf@goingcnc.com
  • Mobile Version
  • WeChat
Copyright © 2006-2024 JiangSu GOING Precision Machine Technology Co.,Ltd
Contact us